Μετάφραση και ανάλυση λέξεων από τεχνητή νοημοσύνη
Σε αυτήν τη σελίδα μπορείτε να λάβετε μια λεπτομερή ανάλυση μιας λέξης ή μιας φράσης, η οποία δημιουργήθηκε χρησιμοποιώντας το ChatGPT, την καλύτερη τεχνολογία τεχνητής νοημοσύνης μέχρι σήμερα:
- πώς χρησιμοποιείται η λέξη
- συχνότητα χρήσης
- χρησιμοποιείται πιο συχνά στον προφορικό ή γραπτό λόγο
- επιλογές μετάφρασης λέξεων
- παραδείγματα χρήσης (πολλές φράσεις με μετάφραση)
- ετυμολογία
daily inspection - translation to ολλανδικά
![Wife of President-elect [[Warren G. Harding]] on cover of The ''Daily News'' (February 5, 1921 front page)](https://commons.wikimedia.org/wiki/Special:FilePath/Finest picture front page.jpg?width=200 "Wife of President-elect [[Warren G. Harding]] on cover of The ''Daily News'' (February 5, 1921 front page)")
![[[Daily News Building]], [[John Mead Howells]] and [[Raymond Hood]], architects, rendering by [[Hugh Ferriss]]. The building housed the paper until the mid-1990s.](https://commons.wikimedia.org/wiki/Special:FilePath/New York Daily News building 1930.jpg?width=200 "[[Daily News Building]], [[John Mead Howells]] and [[Raymond Hood]], architects, rendering by [[Hugh Ferriss]]. The building housed the paper until the mid-1990s.")
.jpg?width=200 "Map of New York Daily News building and garage about 1955")
Ορισμός
Βικιπαίδεια
Automated optical inspection (AOI) is an automated visual inspection of printed circuit board (PCB) (or LCD, transistor) manufacture where a camera autonomously scans the device under test for both catastrophic failure (e.g. missing component) and quality defects (e.g. fillet size or shape or component skew). It is commonly used in the manufacturing process because it is a non-contact test method. It is implemented at many stages through the manufacturing process including bare board inspection, solder paste inspection (SPI), pre-reflow and post-re-flow as well as other stages.
Historically, the primary place for AOI systems has been after solder re-flow or "post-production." Mainly because, post-re-flow AOI systems can inspect for most types of defects (component placement, solder shorts, missing solder, etc.) at one place in the line with one single system. In this way the faulty boards are reworked and the other boards are sent to the next process stage.
